How to replace the Tag battery (SMART V2)

If you have SMART V.2 (with tags as in the picture), follow these few simple steps by watching this video.

• Remove the two screws using a Phillips screwdriver.
• Separate the two sides of the tag by lightly levering the black rubber ring.
• Remove the black rubber ring and then separate the circuit board from its base.
• With a plastic tip (e.g. the cap of a biro), push the battery out of its holder.
• Insert the new battery, making sure it is in the correct direction and removing any protective film.
• Replace the circuit board on its base, centring the holes in the board with the red plastic pins.
• Now apply the rubber ring, matching the two cuts with the plastic notches.
• Place the cover, matching the central plastic notch with the corresponding cut on the rubber ring.
• Ensure that the joints between the two sides of the tag and the rubber ring have been made correctly.
• With the screwdriver and without exerting much force, screw the two screws back in.

CAUTION: Some CR2032 type batteries have a transparent film to isolate the charge and prevent leakage. If this film is present in the new batteries to be replaced in the Tag, it must be removed before fitting the batteries inside the Tag.